SmartAudio/lichee/linux-4.9/drivers/net/wireless/rtl8189es/include/autoconf.h

289 lines
6.8 KiB
C
Executable File

/******************************************************************************
*
* Copyright(c) 2010 - 2012 Realtek Corporation. All rights reserved.
*
* This program is free software; you can redistribute it and/or modify it
* under the terms of version 2 of the GNU General Public License as
* published by the Free Software Foundation.
*
* This program is distributed in the hope that it will be useful, but WITHOUT
* ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or
* FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for
* more details.
*
* You should have received a copy of the GNU General Public License along with
* this program; if not, write to the Free Software Foundation, Inc.,
* 51 Franklin Street, Fifth Floor, Boston, MA 02110, USA
*
*
******************************************************************************/
/*
* Automatically generated C config: don't edit
*/
//***** temporarily flag *******
#define CONFIG_SINGLE_IMG
//***** temporarily flag *******
//***** temporarily flag *******
#define AUTOCONF_INCLUDED
#define RTL871X_MODULE_NAME "8189ES"
#define DRV_NAME "rtl8189es"
#ifndef EFUSE_MAP_PATH
#define EFUSE_MAP_PATH "/system/etc/wifi/wifi_efuse_8189e.map"
#endif
#define CONFIG_SDIO_HCI
#define PLATFORM_LINUX
//#define CONFIG_IOCTL_CFG80211
#ifdef CONFIG_IOCTL_CFG80211
//#define RTW_USE_CFG80211_STA_EVENT /* Indecate new sta asoc through cfg80211_new_sta */
#define CONFIG_CFG80211_FORCE_COMPATIBLE_2_6_37_UNDER
//#define CONFIG_DEBUG_CFG80211
#define CONFIG_SET_SCAN_DENY_TIMER
/*#define SUPPLICANT_RTK_VERSION_LOWER_THAN_JB42*/ /* wpa_supplicant realtek version <= jb42 will be defined this */
#endif
#define CONFIG_EMBEDDED_FWIMG
//#define CONFIG_FILE_FWIMG
//#define CONFIG_SFW_SUPPORTED
#define CONFIG_XMIT_ACK
#ifdef CONFIG_XMIT_ACK
#define CONFIG_ACTIVE_KEEP_ALIVE_CHECK
#endif
#define CONFIG_80211N_HT
#define CONFIG_RECV_REORDERING_CTRL
//#define CONFIG_CONCURRENT_MODE
#ifdef CONFIG_CONCURRENT_MODE
#define CONFIG_TSF_RESET_OFFLOAD // For 2 PORT TSF SYNC.
//#define CONFIG_HWPORT_SWAP //Port0->Sec , Port1 -> Pri
#define CONFIG_RUNTIME_PORT_SWITCH
//#define DBG_RUNTIME_PORT_SWITCH
#define CONFIG_SCAN_BACKOP
#endif
#define CONFIG_AP_MODE
#ifdef CONFIG_AP_MODE
#define CONFIG_INTERRUPT_BASED_TXBCN /* Tx Beacon when driver early interrupt occurs*/
#if defined(CONFIG_CONCURRENT_MODE) && defined(CONFIG_INTERRUPT_BASED_TXBCN)
#undef CONFIG_INTERRUPT_BASED_TXBCN
#endif
#ifdef CONFIG_INTERRUPT_BASED_TXBCN
#define CONFIG_INTERRUPT_BASED_TXBCN_EARLY_INT
/* #define CONFIG_INTERRUPT_BASED_TXBCN_BCN_OK_ERR */
#endif
#define CONFIG_NATIVEAP_MLME
#ifndef CONFIG_NATIVEAP_MLME
#define CONFIG_HOSTAPD_MLME
#endif
//#define CONFIG_FIND_BEST_CHANNEL
#define CONFIG_TX_MCAST2UNI // Support IP multicast->unicast
#endif
//#define CONFIG_CHECK_AC_LIFETIME // Check packet lifetime of 4 ACs.
#define CONFIG_P2P
#ifndef CONFIG_AP_MODE
#undef CONFIG_P2P
#endif
#ifdef CONFIG_P2P
//The CONFIG_WFD is for supporting the Wi-Fi display
#ifndef CONFIG_AP_MODE
#define CONFIG_AP_MODE
#endif
#define CONFIG_WFD
#define CONFIG_P2P_REMOVE_GROUP_INFO
//#define CONFIG_DBG_P2P
#define CONFIG_P2P_PS
//#define CONFIG_P2P_IPS
#define CONFIG_P2P_OP_CHK_SOCIAL_CH
#define CONFIG_CFG80211_ONECHANNEL_UNDER_CONCURRENT //replace CONFIG_P2P_CHK_INVITE_CH_LIST flag
#define CONFIG_P2P_INVITE_IOT
#endif
// Added by Kurt 20110511
#ifdef CONFIG_TDLS
#define CONFIG_TDLS_DRIVER_SETUP
// #ifndef CONFIG_WFD
// #define CONFIG_WFD
// #endif
// #define CONFIG_TDLS_AUTOSETUP
#define CONFIG_TDLS_AUTOCHECKALIVE
#define CONFIG_TDLS_CH_SW /* Enable "CONFIG_TDLS_CH_SW" by default, however limit it to only work in wifi logo test mode but not in normal mode currently */
#endif
#define CONFIG_SKB_COPY //for amsdu
#define CONFIG_LAYER2_ROAMING
#define CONFIG_LAYER2_ROAMING_RESUME
#define CONFIG_LONG_DELAY_ISSUE
#define CONFIG_NEW_SIGNAL_STAT_PROCESS
#define RTW_NOTCH_FILTER 0 /* 0:Disable, 1:Enable, */
#define CONFIG_DEAUTH_BEFORE_CONNECT
/*
* Hardware Related Config
*/
//#define SUPPORT_HW_RFOFF_DETECTED
//#define CONFIG_SW_LED
/*
* Interface Related Config
*/
#define CONFIG_TX_AGGREGATION
//#define CONFIG_SDIO_TX_TASKLET
#define CONFIG_SDIO_RX_COPY
/* #define CONFIG_SDIO_TX_ENABLE_AVAL_INT */
/*
* Others
*/
//#define CONFIG_MAC_LOOPBACK_DRIVER
/*
* Auto Config Section
*/
#if defined(CONFIG_RTL8188E) && defined(CONFIG_SDIO_HCI)
#define CONFIG_RTL8188E_SDIO
#define CONFIG_XMIT_THREAD_MODE
#endif
#define CONFIG_IPS
#define CONFIG_LPS
#if defined(CONFIG_LPS) && defined(CONFIG_SDIO_HCI)
#define CONFIG_LPS_LCLK
#define CONFIG_LPS_SLOW_TRANSITION
#ifdef CONFIG_LPS_LCLK
#define LPS_RPWM_WAIT_MS 300
//#define CONFIG_DETECT_CPWM_BY_POLLING
//#define CONFIG_LPS_RPWM_TIMER
#if defined(CONFIG_LPS_RPWM_TIMER) || defined(CONFIG_DETECT_CPWM_BY_POLLING)
#define LPS_RPWM_WAIT_MS 300
#endif
//#define CONFIG_LPS_LCLK_WD_TIMER // Watch Dog timer in LPS LCLK
#endif
#endif
#ifdef CONFIG_MAC_LOOPBACK_DRIVER
#undef CONFIG_AP_MODE
#undef CONFIG_NATIVEAP_MLME
#undef CONFIG_POWER_SAVING
#undef SUPPORT_HW_RFOFF_DETECTED
#endif
#ifdef CONFIG_MP_INCLUDED
#define MP_DRIVER 1
#define CONFIG_MP_IWPRIV_SUPPORT
// disable unnecessary functions for MP
//#undef CONFIG_IPS
//#undef CONFIG_LPS
//#undef CONFIG_LPS_LCLK
//#undef SUPPORT_HW_RFOFF_DETECTED
#else// #ifdef CONFIG_MP_INCLUDED
#define MP_DRIVER 0
#endif // #ifdef CONFIG_MP_INCLUDED
#define CONFIG_IOL
#ifdef CONFIG_IOL
#define CONFIG_IOL_NEW_GENERATION
#define CONFIG_IOL_READ_EFUSE_MAP
//#define DBG_IOL_READ_EFUSE_MAP
//#define CONFIG_IOL_LLT
#define CONFIG_IOL_EFUSE_PATCH
//#define CONFIG_IOL_IOREG_CFG
//#define CONFIG_IOL_IOREG_CFG_DBG
#endif
#ifdef CONFIG_WOWLAN
//#define CONFIG_ARP_KEEP_ALIVE
#endif
//#define CONFIG_TX_EARLY_MODE
#ifdef CONFIG_TX_EARLY_MODE
#define RTL8188E_EARLY_MODE_PKT_NUM_10 0
#endif
//#endif
#define CONFIG_ATTEMPT_TO_FIX_AP_BEACON_ERROR
/*
* HAL Related Config
*/
//for FPGA VERIFICATION config
#define RTL8188E_FPGA_TRUE_PHY_VERIFICATION 0
#define DISABLE_BB_RF 0
#define CONFIG_RF_GAIN_OFFSET
#define CONFIG_80211D
#ifdef CONFIG_GPIO_WAKEUP
#ifndef WAKEUP_GPIO_IDX
#define WAKEUP_GPIO_IDX 7
#endif
#endif
#define CONFIG_GPIO_API
/*
* Debug Related Config
*/
#define DBG 1
//#define CONFIG_DEBUG /* DBG_871X, etc... */
//#define CONFIG_DEBUG_RTL871X /* RT_TRACE, RT_PRINT_DATA, _func_enter_, _func_exit_ */
#define CONFIG_PROC_DEBUG
#define DBG_CONFIG_ERROR_DETECT
#define DBG_CONFIG_ERROR_RESET
//#define DBG_IO
//#define DBG_DELAY_OS
//#define DBG_MEM_ALLOC
//#define DBG_IOCTL
//#define DBG_TX
//#define DBG_XMIT_BUF
//#define DBG_XMIT_BUF_EXT
//#define DBG_TX_DROP_FRAME
//#define DBG_RX_DROP_FRAME
//#define DBG_RX_SEQ
//#define DBG_RX_SIGNAL_DISPLAY_PROCESSING
//#define DBG_RX_SIGNAL_DISPLAY_SSID_MONITORED "jeff-ap"
//#define DOWNLOAD_FW_TO_TXPKT_BUF 0
//#define DBG_HAL_INIT_PROFILING