/* * drivers/tty/serial/sunxi-uart.h * (C) Copyright 2007-2013 * Reuuimlla Technology Co., Ltd. * Aaron.Maoye * * Some macro and struct of Allwinner UART controller. * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License as * published by the Free Software Foundation; either version 2 of * the License, or (at your option) any later version. * * 2013.6.6 Mintow * Adapt to support sun8i/sun9i of Allwinner. */ #ifndef _SUNXI_UART_H_ #define _SUNXI_UART_H_ #include #include struct sw_uart_pdata { unsigned int used; unsigned int io_num; unsigned int port_no; char regulator_id[16]; struct regulator *regulator; }; #ifdef CONFIG_SERIAL_SUNXI_DMA struct sw_uart_dma { u32 use_dma; /* 1:used */ /* receive and transfer buffer */ char *rx_buffer; /* visual memory */ char *tx_buffer; dma_addr_t rx_phy_addr; /* physical memory */ dma_addr_t tx_phy_addr; u32 rb_size; /* buffer size */ u32 tb_size; /* regard the rx buffer as a circular buffer */ u32 rb_head; u32 rb_tail; u32 rx_size; dma_cookie_t rx_cookie; char tx_dma_inited; /* 1:dma tx channel has been init */ char rx_dma_inited; /* 1:dma rx channel has been init */ char tx_dma_used; /* 1:dma tx is working */ char rx_dma_used; /* 1:dma rx is working */ /* timer to poll activity on rx dma */ char use_timer; int rx_timeout; struct dma_chan *dma_chan_rx, *dma_chan_tx; struct scatterlist rx_sgl, tx_sgl; unsigned int rx_bytes, tx_bytes; }; #endif struct sw_uart_port { struct uart_port port; char name[16]; struct clk *mclk; struct clk *sclk; struct clk *pclk; unsigned char id; unsigned char ier; unsigned char lcr; unsigned char mcr; unsigned char fcr; unsigned char dll; unsigned char dlh; unsigned char rs485; unsigned char msr_saved_flags; unsigned int lsr_break_flag; struct sw_uart_pdata *pdata; #ifdef CONFIG_SERIAL_SUNXI_DMA struct sw_uart_dma *dma; struct hrtimer rx_hrtimer; u32 rx_last_pos; #define SUNXI_UART_DRQ_RX(ch) (DRQSRC_UART0RX + ch) #define SUNXI_UART_DRQ_TX(ch) (DRQSRC_UART0RX + ch) #endif /* for debug */ #define MAX_DUMP_SIZE 1024 unsigned int dump_len; char *dump_buff; struct proc_dir_entry *proc_root; struct proc_dir_entry *proc_info; struct pinctrl *pctrl; struct serial_rs485 rs485conf; }; /* register offset define */ #define SUNXI_UART_RBR (0x00) /* receive buffer register */ #define SUNXI_UART_THR (0x00) /* transmit holding register */ #define SUNXI_UART_DLL (0x00) /* divisor latch low register */ #define SUNXI_UART_DLH (0x04) /* diviso latch high register */ #define SUNXI_UART_IER (0x04) /* interrupt enable register */ #define SUNXI_UART_IIR (0x08) /* interrupt identity register */ #define SUNXI_UART_FCR (0x08) /* FIFO control register */ #define SUNXI_UART_LCR (0x0c) /* line control register */ #define SUNXI_UART_MCR (0x10) /* modem control register */ #define SUNXI_UART_LSR (0x14) /* line status register */ #define SUNXI_UART_MSR (0x18) /* modem status register */ #define SUNXI_UART_SCH (0x1c) /* scratch register */ #define SUNXI_UART_USR (0x7c) /* status register */ #define SUNXI_UART_TFL (0x80) /* transmit FIFO level */ #define SUNXI_UART_RFL (0x84) /* RFL */ #define SUNXI_UART_HALT (0xa4) /* halt tx register */ #define SUNXI_UART_RS485 (0xc0) /* RS485 control and status register */ /* register bit field define */ /* Interrupt Enable Register */ #define SUNXI_UART_IER_PTIME (BIT(7)) #define SUNXI_UART_IER_RS485 (BIT(4)) #define SUNXI_UART_IER_MSI (BIT(3)) #define SUNXI_UART_IER_RLSI (BIT(2)) #define SUNXI_UART_IER_THRI (BIT(1)) #define SUNXI_UART_IER_RDI (BIT(0)) /* Interrupt ID Register */ #define SUNXI_UART_IIR_FEFLAG_MASK (BIT(6)|BIT(7)) #define SUNXI_UART_IIR_IID_MASK (BIT(0)|BIT(1)|BIT(2)|BIT(3)) #define SUNXI_UART_IIR_IID_MSTA (0) #define SUNXI_UART_IIR_IID_NOIRQ (1) #define SUNXI_UART_IIR_IID_THREMP (2) #define SUNXI_UART_IIR_IID_RXDVAL (4) #define SUNXI_UART_IIR_IID_LINESTA (6) #define SUNXI_UART_IIR_IID_BUSBSY (7) #define SUNXI_UART_IIR_IID_CHARTO (12) /* FIFO Control Register */ #define SUNXI_UART_FCR_RXTRG_MASK (BIT(6)|BIT(7)) #define SUNXI_UART_FCR_RXTRG_1CH (0 << 6) #define SUNXI_UART_FCR_RXTRG_1_4 (1 << 6) #define SUNXI_UART_FCR_RXTRG_1_2 (2 << 6) #define SUNXI_UART_FCR_RXTRG_FULL (3 << 6) #define SUNXI_UART_FCR_TXTRG_MASK (BIT(4)|BIT(5)) #define SUNXI_UART_FCR_TXTRG_EMP (0 << 4) #define SUNXI_UART_FCR_TXTRG_2CH (1 << 4) #define SUNXI_UART_FCR_TXTRG_1_4 (2 << 4) #define SUNXI_UART_FCR_TXTRG_1_2 (3 << 4) #define SUNXI_UART_FCR_TXFIFO_RST (BIT(2)) #define SUNXI_UART_FCR_RXFIFO_RST (BIT(1)) #define SUNXI_UART_FCR_FIFO_EN (BIT(0)) /* Line Control Register */ #define SUNXI_UART_LCR_DLAB (BIT(7)) #define SUNXI_UART_LCR_SBC (BIT(6)) #define SUNXI_UART_LCR_PARITY_MASK (BIT(5)|BIT(4)) #define SUNXI_UART_LCR_EPAR (1 << 4) #define SUNXI_UART_LCR_OPAR (0 << 4) #define SUNXI_UART_LCR_PARITY (BIT(3)) #define SUNXI_UART_LCR_STOP (BIT(2)) #define SUNXI_UART_LCR_DLEN_MASK (BIT(1)|BIT(0)) #define SUNXI_UART_LCR_WLEN5 (0) #define SUNXI_UART_LCR_WLEN6 (1) #define SUNXI_UART_LCR_WLEN7 (2) #define SUNXI_UART_LCR_WLEN8 (3) /* Modem Control Register */ #define SUNXI_UART_MCR_MODE_MASK (BIT(7)|BIT(6)) #define SUNXI_UART_MCR_MODE_RS485 (2 << 6) #define SUNXI_UART_MCR_MODE_SIRE (1 << 6) #define SUNXI_UART_MCR_MODE_UART (0 << 6) #define SUNXI_UART_MCR_AFE (BIT(5)) #define SUNXI_UART_MCR_LOOP (BIT(4)) #define SUNXI_UART_MCR_RTS (BIT(1)) #define SUNXI_UART_MCR_DTR (BIT(0)) /* Line Status Rigster */ #define SUNXI_UART_LSR_RXFIFOE (BIT(7)) #define SUNXI_UART_LSR_TEMT (BIT(6)) #define SUNXI_UART_LSR_THRE (BIT(5)) #define SUNXI_UART_LSR_BI (BIT(4)) #define SUNXI_UART_LSR_FE (BIT(3)) #define SUNXI_UART_LSR_PE (BIT(2)) #define SUNXI_UART_LSR_OE (BIT(1)) #define SUNXI_UART_LSR_DR (BIT(0)) #define SUNXI_UART_LSR_BRK_ERROR_BITS 0x1E /* BI, FE, PE, OE bits */ /* Modem Status Register */ #define SUNXI_UART_MSR_DCD (BIT(7)) #define SUNXI_UART_MSR_RI (BIT(6)) #define SUNXI_UART_MSR_DSR (BIT(5)) #define SUNXI_UART_MSR_CTS (BIT(4)) #define SUNXI_UART_MSR_DDCD (BIT(3)) #define SUNXI_UART_MSR_TERI (BIT(2)) #define SUNXI_UART_MSR_DDSR (BIT(1)) #define SUNXI_UART_MSR_DCTS (BIT(0)) #define SUNXI_UART_MSR_ANY_DELTA 0x0F #define MSR_SAVE_FLAGS SUNXI_UART_MSR_ANY_DELTA /* Status Register */ #define SUNXI_UART_USR_RFF (BIT(4)) #define SUNXI_UART_USR_RFNE (BIT(3)) #define SUNXI_UART_USR_TFE (BIT(2)) #define SUNXI_UART_USR_TFNF (BIT(1)) #define SUNXI_UART_USR_BUSY (BIT(0)) /* Halt Register */ #define SUNXI_UART_HALT_LCRUP (BIT(2)) #define SUNXI_UART_HALT_FORCECFG (BIT(1)) #define SUNXI_UART_HALT_HTX (BIT(0)) /* RS485 Control and Status Register */ #define SUNXI_UART_RS485_RXBFA (BIT(3)) #define SUNXI_UART_RS485_RXAFA (BIT(2)) /* The global infor of UART channel. */ #if defined(CONFIG_ARCH_SUN8IW5) || defined(CONFIG_ARCH_SUN8IW17) #define SUNXI_UART_NUM 5 #endif #if defined(CONFIG_ARCH_SUN8IW8) #define SUNXI_UART_NUM 3 #endif #if defined(CONFIG_ARCH_SUN8IW11) #define SUNXI_UART_NUM 8 #endif #if defined(CONFIG_ARCH_SUN8IW10) || defined(CONFIG_ARCH_SUN50IW1) #define SUNXI_UART_NUM 6 #endif #if defined(CONFIG_ARCH_SUN8IW12) \ || defined(CONFIG_ARCH_SUN8IW15) \ || defined(CONFIG_ARCH_SUN8IW6) \ || defined(CONFIG_ARCH_SUN50IW8) #define SUNXI_UART_NUM 5 #endif #if defined(CONFIG_ARCH_SUN50IW2) \ || defined(CONFIG_ARCH_SUN50IW3) \ || defined(CONFIG_ARCH_SUN50IW6) \ || defined(CONFIG_ARCH_SUN8IW7) \ || defined(CONFIG_ARCH_SUN8IW18) #define SUNXI_UART_NUM 4 #endif #if defined(CONFIG_ARCH_SUN3IW1) #define SUNXI_UART_NUM 3 #endif #ifndef SUNXI_UART_NUM #define SUNXI_UART_NUM 1 #endif /* In 50/39 FPGA, two UART is available, but they share one IRQ. So we define the number of UART port as 1. */ #ifndef CONFIG_EVB_PLATFORM #undef SUNXI_UART_NUM #define SUNXI_UART_NUM 1 #endif #if defined(CONFIG_ARCH_SUN8IW12) \ || defined(CONFIG_ARCH_SUN8IW15) \ || defined(CONFIG_ARCH_SUN8IW18) \ || defined(CONFIG_ARCH_SUN50IW3) \ || defined(CONFIG_ARCH_SUN50IW6) \ || defined(CONFIG_ARCH_SUN50IW8) \ || defined(CONFIG_ARCH_SUN8IW17) #define SUNXI_UART_FIFO_SIZE 256 #elif defined(CONFIG_ARCH_SUN3IW1) #define SUNXI_UART_FIFO_SIZE 32 #else #define SUNXI_UART_FIFO_SIZE 64 #endif #define SUNXI_UART_DEV_NAME "uart" struct platform_device *sw_uart_get_pdev(int uart_id); #endif /* end of _SUNXI_UART_H_ */