42 lines
1.4 KiB
Plaintext
42 lines
1.4 KiB
Plaintext
|
#!/bin/sh /etc/rc.common
|
||
|
|
#
|
||
|
|
# udev This is a minimal non-LSB version of a UDEV startup script. It
|
||
|
|
# was derived by stripping down the udev-058 LSB version for use
|
||
|
|
# with buildroot on embedded hardware using Linux 2.6.34+ kernels.
|
||
|
|
#
|
||
|
|
# You may need to customize this for your system's resource limits
|
||
|
|
# (including startup time!) and administration. For example, if
|
||
|
|
# your early userspace has a custom initramfs or initrd you might
|
||
|
|
# need /dev much earlier; or without hotpluggable busses (like USB,
|
||
|
|
# PCMCIA, MMC/SD, and so on) your /dev might be static after boot.
|
||
|
|
#
|
||
|
|
# This script assumes your system boots right into the eventual root
|
||
|
|
# filesystem, and that init runs this udev script before any programs
|
||
|
|
# needing more device nodes than the bare-bones set -- /dev/console,
|
||
|
|
# /dev/zero, /dev/null -- that's needed to boot and run this script.
|
||
|
|
|
||
|
|
START=80
|
||
|
|
STOP=80
|
||
|
|
|
||
|
|
UDEV_BIN=/sbin/udevd
|
||
|
|
# Check for config file and read it
|
||
|
|
UDEV_CONFIG=/etc/udev/udev.conf
|
||
|
|
|
||
|
|
start(){
|
||
|
|
test -r $UDEV_CONFIG || exit 6
|
||
|
|
. $UDEV_CONFIG
|
||
|
|
printf "Populating ${udev_root:-/dev} using udev: "
|
||
|
|
printf '\000\000\000\000' > /proc/sys/kernel/hotplug
|
||
|
|
$UDEV_BIN -d || (echo "FAIL" && exit 1)
|
||
|
|
udevadm trigger --type=subsystems --action=add
|
||
|
|
udevadm trigger --type=devices --action=add
|
||
|
|
udevadm settle --timeout=30 || echo "udevadm settle failed"
|
||
|
|
echo "done"
|
||
|
|
}
|
||
|
|
|
||
|
|
stop(){
|
||
|
|
udevadm control --stop-exec-queue
|
||
|
|
killall udevd
|
||
|
|
}
|
||
|
|
|